13
5140-011
212CC/4-CYCLE GAS REAR TINE TILLER
INTENDED USE
1. This gas-powered rear tine rotary tiller has been designed for tilling.
2. The machine is to be used only for its prescribed purpose. Any other use is
deemed to be a case of misuse.
3. The user/operator and not the manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
4. Please note that our equipment has not been designed for use in commercial,
trade or industrial applications. Our warranty will be voided if the machine is
used in commercial, trade or industrial businesses or for equivalent purposes.
ASSEMBLY
Read and follow the assembly instructions. Do not discard, any parts or materials
until the unit is assembled.
References to the right or left side of the tiller are from the viewpoint of the
operator’s position behind the tiller.
WARNING
• Do not operate tiller if it is damaged or not completely and correctly assembled.
• Before doing any assembly or maintenance to the unit, remove the wire from the
spark plug.
• Always wear ANSI compliant safety glasses with side shields while assembling
the tiller.
TO REMOVE TILLER FROM CARTON
1. Remove all parts and packaging components.
2. Use a utility knife to cut all four vertical edges and lay the side panels flat around
the tiller.
3. Remove any remaining packaging.
The tiller comes fully assembled except for a few parts. The following instructions
will help you complete the tiller assembly.
INSTALLING THE WHEELS
Free-wheel Position For Transport
1. Remove lock pin. Slide wheel inward toward machine.
2. Insert pin in axle only, fold lock pin ring to secure pin to axle.
3. Wheel should turn freely on axle.
To Next Page
