11
3. Do not remove fuel cap or add fuel with the engine running or while hot.
4. Do not refuel indoors or in enclosed spaces.
5. Do not store the machine or fuel container, or refuel, where there is an open flame,
spark, or pilot light such as on a water heater or other appliance.
6. If fuel is spilled, do not attempt to start the engine and avoid creating any source
of ignition until fuel vapors have dissipated.
7. To help prevent fires: keep the machine free of grass, leaves, or other debris build
up; clean up oil or fuel spillage and remove any fuel soaked debris; allow
machine to cool before storing.
8. Use extra care in handling gasoline and other fuels. They are flammable and
vapors are explosive.
Explosion!
1. Supply petrol before starting the engine. Do not remove the tank cap and do not
supply petrol while the engine is running or hot.
2. Should the petrol run over, do not attempt to start the engine, but move the
machine well away from the spot where you spilled the petrol. Avoid any cause of
spark or fire until the petrol fumes have completely disappeared.
3. Close back the petrol tank and the containers by safely tightening their caps.
4. Replace the muffler if it is faulty or damaged.
5. Before use, always visually check that the blade, the blade fastening screws, and
the cutters are not worn or damaged. Replace any damaged or worn blades, as
well as their fastening screws in correct series to maintain proper balancing.
Repairs and maintenance of mechanical parts must be done by an authorized
service center.
RULES FOR CORRECT OPERATION
Do not operate the engine in a conned or restricted area where
the dangerous carbon monoxide contained in the exhaust fumes may build up.
1. Only operate on grounds that are lit by daylight or by adequate artificial lighting.
2. Before starting the engine, disengage the blade, place the gear shift in neutral “N”
and engage the parking brake.
3. Avoid using the lawn mower on wet grass as much as possible.
4. Do not operate on excessively steep slopes. Check the limits indicated in the
operator’s manual.
To Next Page
Loading...
