- 3 -
3. Maintenance of the Instrument
The block wells should be cleaned by a cloth dampened with alcohol to ensure
good heat transmission between the block and the test tube. If there are marks, dirt
or stains on the instrument exterior, clean them with a cloth dampened with water
or a mild detergent solution.
Before connectivity to a power source, check that the voltage
listed on the serial number label (on the bottom or back side of
the unit) to ensure that it matches the voltage available in your
area.
Be sure to install the Instrument in a cool, dry location away
from any direct sunlight or strong light sources. Additionally
the instrument should be kept away from corrosive gas,
magnetic fields and dusty environments. Keep the instrument
and the air vents at least 4 inches from walls, other instruments
or any obstructions.
Shut the power off when you finish your work. Unplug the
machine if it will not be operated for a long time period and cover
it with a cloth or plastic paper for protection from dust particles
Immediately unplug the instrument from the outlet and
contact the vendor in the event of:
Fire or smoke.
Liquid has gotten into the Instrument;
Abnormal operation: such as abnormal sound or smell.
Instrument has been dropped or outer case is damaged.
The function has visibly changed.
Always shut the power off when cleaning the Instrument.
When cleaning the block wells, do not apply the cleaning liquid
directly to the block, use a dampened cloth. Do not use strong or
corrosive cleaning agents.
The Main power switch is on the rear of the device,
push “I” to power on the instrument, and push “O” to
power off.
To Next Page
Loading...
Need help?
General