4
2620-176
DO NOT ABUSE CORD
Never carry mixer by cord or yank it to disconnect it from socket.
Keep cord from heat, oil and sharp edges.
EXTENSION CORDS
Extension cords must be no longer than 50 m/164' in length. The
wire section must be 1.5mm
2
/
3
/64"
2
on 120V to allow sufficient 2
current flow to the motor. Improper use of extension cords may
cause inefficient operation of the mixer which can result in over-
heating and motor damage. Only extension cords to H07RN-F spec-
ification intended for outdoor purpose may be used. Avoid use of
free and inadequately insulated connections. Connections must be
made with protected material suitable for outdoor use. Make sure
that any extension cord connections are dry and safe. Ensure that
the extension cord is carefully laid out avoiding liquids, sharp edg-
es and places where vehicles might run over it. Avoid allowing the
extension cord to be trapped underneath the mixer. Unroll it fully or
it will overheat and could catch fire.
AVOID ELECTRICAL SHOCK
Check that the electric circuit is adequately protected and that it cor-
responds with the power, voltage and frequency of the motor. Do
not plug or unplug the motor while standing in or around damp or
wet ground. Do not use the mixer in wet or damp areas or expose
it to rain. Prevent body contact with grounded surfaces: pipes, radi-
ators, ranges, and refrigerator enclosures. Make sure your fingers
do not touch the plug’s metal prongs when plugging or unplugging
the mixer.
KEEP VISITORS AND CHILDREN AWAY
Keep unauthorized persons away from the mixer. Do not allow chil-
dren to handle or climb on or in the mixer.
DO NOT OVERREACH
Keep proper footing and balance at all times when loading or un-
loading the mixer. Never stand on mixer. Serious injury could oc-
cur if the mixer is tipped or if the moving parts are unintentionally
contacted. Do not store anything above or near the mixer where
anyone might stand on the mixer to reach them.
AVOID INJURY FROM UNEXPECTED ACCIDENT
Keep hands out of the way of all moving parts. Do not place any
part of your body or any tool, like shovel in the drum during oper-
ation. When operating, do not pass hands through the clearance
between frame and support arm or the one between the drum and
support arm.
DON'T FORCE TOOL
It will do a better and safer job at its design rate. Always work within
the rated capacity. Do not start the motor if the drum is fully loaded.
To Next Page
Loading...
Need help?
General