7
CEMENT MIXER - OWNER'S MANUAL
ASSEMBLY INSTRUCTIONS
It is recommended that two people assist in the assembly.
THE STAND
1. With a split pin inserted into the in-
ner holes in each stub axle, place a
flat washer, then a wheel followed
by another flat washer. Insert an-
other split pin into the axle holes
outside each flat washer. Bend
each side of the pins outward so
they do not fall out.
A
4
B
2
M8 70
C
2
M8 70
2. With the frame lying on its side, at-
tach the support leg as shown. In-
sert two M8X70 hex bolts through
the holes from one side, then flat
washers, lock washers and nuts
from the other side.
3. Turn the frame over and attach the
axle bracket with wheels in the
same manner.
4. Make sure all bolts and nuts are
tightened.
To Next Page
