Bender COMTRAXX CP9 Series - Dimension Diagram; Flush-Mounting Enclosure CP907

15
CP9xx_D00349_08_M_XXEN/02.2022
4.1.1 Dimension diagram
4.1.2 Flush-mounting enclosure CP907
Fig. 4.1: Flush-mounting enclosure CP907
Mounting of flush-mounting enclosures
The supplied flush-mounting enclosures are only suitable for mounting in cavity
walls. In drywall and stud frame constructions, the enclosures must be screwed
at right angles to battens or to the stud frame structure. The enclosure must not
warp during mounting. The wall surface must be even.
Tightening torque
The tightening torque for the mounting screws may be in a range between 0.8
…1 Nm.
Device dimensions
Type
Dimensions (mm) ±1
ab c
CP907 226 144 176 (7")
CP915 505 350 386 (15.6")
CP924 654 441 610 (24")
Installation dimensions enclosure
Type Enclosure
Dimensions (mm) Required
installation
depth
ab
CP907
Flush-
mounting
212 124 75
Surface-
mounting
299 173 —
CP 915
Flush-
mounting
461 306 92
CP924
Flush-
mounting
610 398 95
Glass thickness: 3 mm
COMTRAXX ®
a
cb
212
377
75
216
124
128
Dimensions in mm