9
CP9xx_D00349_08_M_XXEN/02.2022
2. Safety instructions
2.1 General safety instructions
Part of the device documentation in addition to this manual is the enclosed supplement " Safety in-
structions for Bender products".
2.2 Work activities on electrical installations
If the device is being used in a location outside the Federal Republic of Germany, the applicable local
standards and regulations must be complied with. The European standard EN 50110 can be used as
a guide.
2.3 Intended use
CP9xx alarm indicator and operator panels display alarms, measured values and states of devices.
These include, for example:
All Bender devices with BMS bus or BCOM interface
Bender devices (PEM, energy meters,…) with Modbus RTU or Modbus TCP interface
Other devices with Modbus RTU or Modbus TCP interface
In addition, the data is available via the Modbus TCP protocol. This allows coupling to a higher-level
building control system as well as visualisation and evaluation using standard web browsers.
Operation and settings are made via the COMTRAXX® user interface integrated in the device.
Any other use than that described in this manual is regarded as improper.
Only qualified personnel are permitted to carry out the work necessary to in-
stall, commission and run a device or system.
Risk of fatal injury due to electric shock!
Touching live parts of the system carries the risk of:
An electric shock
Damage to the electrical installation
Destruction of the device
Before installing and connecting the device, make sure that the installa-
tion has been de-energised. Observe the rules for working on electrical in-
stallations.
To Next Page
Loading...
