Mounting, connection and commissioning
21
CP9xx_D00349_08_M_XXEN/02.2022
4. Attach the front plate to the built-in flush-mounting enclosure.
– CP915
–CP924
Hold the display unit from above in front of the flush-mounting enclosure.
Place the two mounting hooks behind the upper snap locks of the flush-mounting enclosure (see
red markings).
Lower the display and slide it into the flush-mounting enclosure.
5. When pushing in the display, the spring force of the snap locks must be overcome. Make sure
that no wiring gets jammed in the process.
6. When removing the display unit, it is important that you only place the suction lifter in the side
area of the display and carefully remove the display unit from the snap locks.
To Next Page
Loading...
