BendPak RBJ15000 - User Manual

Other manuals for BendPak RBJ15000

Service Manual12 pages

Questions and Answers

M
morgan11Jul 26, 2025
Why BendPak Lifting Systems jack raises load but does not stay up?
- M
  Mr. Eric ShawJul 26, 2025
  The BendPak Lifting Systems' Rolling Bridge Jack is designed for raising and lowering loads, not for indefinite holding without a Safety Lock. Ensure you engage the Safety Lock at the desired height. Also, check for Hydraulic Fluid leaks.
W
williamcooperJul 30, 2025
What to do if BendPak Lifting Systems jack does not lift load?
- D
  David WhitakerJul 30, 2025
  If your BendPak Lifting Systems jack isn't lifting, first ensure the load isn't too heavy. Then, verify the Rolling Bridge Jack receives appropriate air pressure and that the Air-Operated Hydraulic Pump has sufficient Hydraulic Fluid. Finally, check for dirt in the hydraulic system; if present, replace the Hydraulic Fluid and clean the system.
D
Dustin SolisAug 4, 2025
How to troubleshoot BendPak Lifting Systems jack that does not move along Utility Rail?
- U
  unelsonAug 5, 2025
  If the BendPak Lifting Systems jack isn't moving along the Utility Rail, ensure the Utility Rail Channels and Lips are free of obstructions. Also, confirm the Rolling Bridge Jack is correctly situated on the Utility Rail Channel or Lip. It is also important to check with BendPak to ensure the Rolling Bridge Jack is installed on an approved Lift.
B
Brian SmithAug 9, 2025
What to do if BendPak RBJ15000 do not lift the load?
- B
  Brian RiceAug 9, 2025
  If your BendPak Jacks don't lift the load, there are several potential reasons. First, ensure that the load isn't too heavy. Second, verify that the jack receives the correct air pressure from the air supply. Also, check if the air hydraulic pump contains sufficient hydraulic oil. Finally, ensure that dirt hasn't entered the hydraulic system. If dirt has contaminated the system, replace the hydraulic oil and clean the system.
A
Alyssa WeaverAug 14, 2025
Why BendPak Jacks raises load but does not stay up?
- S
  sherisanchezAug 15, 2025
  If your BendPak Jacks raise the load but it doesn't stay up, ensure you put the jack into a locking position when the load reaches the desired height. Remember that the jack is designed to raise and lower loads; it isn't designed to hold a load indefinitely if the load is not in a locked position.
J
Jeffrey HaydenAug 19, 2025
How to fix BendPak RBJ15000 Jacks that do not move along utility rail?
- N
  Nicholas FryAug 19, 2025
  If your BendPak Jacks don't move along the utility rail, ensure that the utility rail channel and lip are free of any obstructions. Also, make sure the jack is correctly situated on the utility rail channel or lip and is installed on an approved lift.