EasyManua.ls Logo

BENE LEVEL LIFT - Safety Instructions; General Operation and User Safety; Clearances and Obstacle Awareness; Control Mechanism and Modification

BENE LEVEL LIFT
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
77
SAFETY INSTRUCTIONS
1
This device can be used by children age 8 or
older and by persons with physical, sensory or
mental disabilities or by those who lack experi-
ence and knowledge if they are supervised or
were instructed on the safe use of the device and
understand the resulting dangers. Children must
not play with the device. Children must not clean
or service the device without supervision.
5
Do not place any objects or body parts between
stationary and movable pieces.
2
Unplug the power cord in case of smoke, smell
or unusual noise: Disconnect the power cable.
6
The height can be adjusted only in the incre-
mental mode. In case an obstacle is encountered,
or there are functional errors, stop the adjustment
immediately.
3
Make sure no objects or parts of the body are
caught in when operating the drive.
7
Make sure adjacent objects are placed at a
minimum distance of 25 mm to prevent them
from being squeezed or sheared.
4
Do not adjust the height of the furniture if
other people are nearby.
8
Make sure that there are safety gaps of at least
25 mm for movable parts (this also applies to
organisational elements that are attached above
or below the furniture or hanging from nearby
walls, as well as to building fixtures, such as open
windows).
9
The protection against uncontrolled movement
does not prevent objects and not people (body
parts) being trapped! For physical reasons, “soft”
obstacles are not easily recognised and evaluated,
if at all.
Please observe safety instructions! Improper operation of the system may result in personal
injury and cause hazard to objects.
10
If the desk hits an obstacle, that obstacle
might be damaged (scratching, marks, etc.) be-
cause the desk is lifted at nominal speed.
11
It is not allowed to change or modify the con-
trol mechanism or the control element.

Related product manuals