Beninca IRI.KPAD - Operation as Proximity Switch

24
Function Sequence
1
if the acoustic indicator is to
be activated
Press 1 (4 beeps) then Press 1 (2 beeps
as confirmation)
if the acoustic indicator is to
be deactivated
Press 1 (4 beeps) then Press 0 (2 beeps
as confirmation)
2
if the back light is to be
activated
Press 2 (4 beeps) then Press 1 (2 beeps
as confirmation)
if the back light is to be
deactivated
Press 2 (4 beeps) then Press 0 (2 beeps
as confirmation)
3
Press 3 (4 beeps), then press
1 (2 beeps confirm)
Enable re-activation with asterisk key ()
Press 3 (4 beeps), then press
0 (2 beeps confirm)
Disable re-activation with all keys.
4
Press 4 (4 beeps), then press
1 (2 beeps confirm)
Enable before pressing re-
activation+code
Press 4 (4 beeps), then press
0 (2 beeps confirm)
Disable before pressing re-
activation+code
5
Press 5 (4 beeps), then press
1 (2 beeps confirm)
Enable 3 min. block after 5 wrong codes
Press 5 (4 beeps), then pres 0
(2 beeps confirm)
Disable 3 min. block after 5 wrong codes
MENU 7 (OPERATION AS PROXIMITY SWITCH)
By activating this function, the keypad sends a radio control also when the system
is activated (first touch).
This might be useful, for example, to activate a courtesy light in the keypad area.
Around 2 seconds are needed for this function at every activation of the device.
During this period of time it is not possible to type any access codes.
After typing key 7, the function activation phase is entered, indicated with 2 beeps
followed by an interval. In the factory configuration this function is disabled.
- Type in 1 if the function is to be activated
- Type in 0 if the function is to be deactivated.
If 1 is typed in, three beeps followed by an interval are heard.
The device awaits for the command to specify the coding type of the code which
will be transmitted when the IRI.KPAD is activated.
- Type 1 > (2 beeps) if a Rolling-Code is desired.
- Type 2 > (2 beeps) if an Advanced rolling code (ARC) is desired.
- Type 3 >(2 beeps) if a Fixed Code is desired.
Note: If you are using only one receiver, the type of encoding must match that of
the Administrator PIN entered.