TABLE 1
Mode LED Function Operations
0 Off No function Normal status.
Press the button P
1 Red Memorise channel 1
The red LED will light up, wait 3 secs, the LED will go out and light up again,
press within 5 secs the button on the transmitter to associate with channel 1.*
Press within 3 secs the button P
2 Green
Memorise channel 2 (only for
dual channel receivers “RR.2”)
The green LED will light up, wait 3 secs, the LED will go out and light up
again, press within 5 secs the button of the transmitter to associate with
channel 2.*
Press within 3 secs the button P
3 Orange
Memorise automatically
channels 1 and 2
(only for dual channel receivers
“RR.2”)
The orange LED will light up, wait 3 secs, the LED will go out and light up
again, press within 5 secs any button on the transmitter.
Button 1 will be associated with channel 1, button 2 with channel 2.*Il tasto 1
verrà associato al canale 1, il tasto 2 verrà associato al canale 2.*
Press within 3 secs the button P
4
Red
Blinking
Set channel 1 times
The LED will give 5 rapid blinks. If button P is pressed during these 5 blinks
the next mode is entered. After the 5 rapid blinks the Times menu is entered.
See section “Times Mode”
Press within 3 secs the button P
5
Green
Blinking
Set channel 2 times
(only for dual channel receivers
“RR.2”)
The LED will give 5 rapid blinks. If button P is pressed during these 5 blinks
the next mode is entered. After the 5 rapid blinks the Times menu is entered.
See section “Times Mode”
Press within 3 secs the button P
0 LED Off No function Normal status.
To Next Page
Loading...
