Need help?Do you have a question about the Bennett Marine AutoTrim Pro and is the answer not in the manual?
Details the main user interface component of the AutoTrim Pro system.
Describes the sensor and processor unit for the AutoTrim Pro system.
Outlines initial steps and components required for installation.
Guidance on locating and mounting the ATP Helm Display on the boat helm.
Instructions for mounting the ATP Control Unit horizontally, parallel to the boat's keel.
Step-by-step guide for mounting the ATP Helm Display, including drilling and wiring.
Details on mounting the control unit, connecting power, and system wiring.
Steps to test the system after installation, including power and button checks.
Procedures to verify the extension of port and starboard actuators during system testing.
Illustrates the wiring configuration for a single helm display setup.
Steps to orient the system and set the idle angle for proper operation.
How to set the planing angle to identify the boat's planing mode.
Guide to storing and activating preferred pitch and roll attitudes.
Explains the basic principles of trim tab operation and their effect on the boat.
Advice on achieving optimal boat attitude and getting used to trim tab feel.
Discusses specific operational conditions and essential safety guidelines.
Guidance on operating in windy chop, rough seas, and following seas.
Explains the functions of buttons and LED indicators on the helm display.
Details the four basic control features integrated into the ATP Helm Display.
Explains the meaning of yellow and red LEDs for trim tab position and sensor status.
Describes the function of the sun and moon buttons for adjusting display brightness.
Explains how to use the manual buttons to control trim tabs, including port/stbd bow adjustments.
Details the one-touch functions to fully retract or deploy both trim tabs.
Instructions for fully retracting tabs using the ALL UP button and its effects.
Explains how to activate stored favorite pitch and roll positions.
Guide to manually adjusting the boat attitude and storing it as a favorite.
Procedures for initiating and discontinuing automatic trim tab control.
Identifies basic boat operating states used by the ATP system.
Explains how the ATP system reacts to various operating states.
Details how the system handles Hole Shot and Rough Seas conditions.
Addresses problems with the ATP Helm Display not illuminating or going dark.
Covers issues related to wiring, communication errors between display and control unit.
Explains why the blue LEDs above FAV1/FAV2 might flash, indicating orientation issues.
Troubleshoots tabs not retracting or LEDs not turning off when ignition is turned off.
Addresses scenarios where trim tabs do not respond to button presses on the helm display.
Solutions for when FAV buttons don't initiate auto mode or system exits auto mode.
Explains no response from ALL Up or ALL Down buttons, usually due to tabs being in position.
Reasons why the system might exit FAV mode, including manual inputs or rough seas.
Issues where the system tries to maintain an incorrect position or has power brownouts.
Problems related to actuators wired backwards or incorrect control unit installation/orientation.
Addresses the system not automatically retracting tabs when the boat is idling or at rest.
Explains why the system may not deploy tabs during acceleration, potentially due to slow acceleration.
Reasons for the system retracting tabs at high speeds, potentially due to planning angle settings.
Outlines the process for making a warranty claim and returning parts.
Details the limitations, exclusions, and remedies for the product warranty.
General| Brand | Bennett Marine |
|---|---|
| Model | AutoTrim Pro |
| Category | Boating Equipment |
| Language | English |
To Next Page
