3
IMPORTANT SAFETY INSTRUCTIONS
WARNING! ELECTRICAL SHOCK HAZARD
Improper connection of the equipment-grounding conductor can result in a risk of electrical shock.
Check with a qualified electrician or service person if you are unsure if an outlet is properly
grounded. DO NOT modify the plug provided with the appliance to fit an outlet, have a proper outlet
installed by a qualified electrician.
MAINS POWER CONNECTION
The following should be observed when connecting the high-pressure washer to the electric
installation:
• The electric installation must be made by a certified electrician and comply with IEC-364
• It is recommended that the electric supply to this appliance should include either a residual current
device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms
IMPORTANT!
Only use water without any impurities.
If there is a risk of sand in the inlet water (from boreholes etc), an additional filter should be mounted
SAFETY DEVICES
• The unloader valve can reduce pressure if it exceeds pre-set values
• The Spray Gun features a Trigger Lock device. When activated, the spray gun cannot be operated
• A thermal sensor protects the motor against overloading. The machine will restart after a few
minutes when the thermal sensor has cooled
• This high-pressure washer has been developed for domestic use for the following:
Cars, motorbikes, boats, caravans, trailers, patios/driveways/flagstones, woodwork, brickwork,
barbecues, garden furniture, garden tools
• Only use the high-pressure washer for purposes described in this manual
• The safety precautions must be observed to prevent damage to the machine, to the surface being
cleaned or from causing severe injuries to people or animals
To Next Page
Loading...
Need help?
General