BenQ DC 5530 User’s Manual
English
Using the DC P500 21
[]
Startup
Image
[]
To set a startup image that is displayed every time
you power on the camera, follow the steps below.
1. Select [ ], and then you will be prompted
to select a startup image. Use the
[ ]/[ ]/[ ]/[ ] buttons to select
the image you prefer.
2. If you are not satisfied with the pre-installed
images, you may move to the bottom right
corner of the LCD monitor to customize your
startup image by selecting the images you like.
3. After the selection is done, press the OK button
to confirm, and then press the [ ] to exit.
[]
Power Save
[]
[]
[]
[]
If the camera is idle for a certain period of time
while the camera is powered on, it will switch to
power-saving state according to your settings. If the
camera is in power-saving state, re-activate it by
pressing any button.
– Off/30 sec./1 min./3 min.
If the camera is idle for 5 minutes, the
camera will power off automatically.
[]
QuickView
[]
[]
Allows you to get a quick preview immediately after
an image is captured. The preview shows briefly and
then you may continue to capture the next image.
–On/Off
[]
Digital
Zoom
[]
[]
Allows you to activate or deactivate Digital Zoom
according to your preferences.
–On/Off
[]
Power On
[]
[]
Allows you to activate or deactivate the function of
powering up from Inst. REC and Inst. Play buttons.
[On]: enables the function of powering up the cam-
era from the Inst. REC and Inst. Play buttons.
[Off]: disable the function of powering up the cam-
era from Inst. REC and Inst. Play buttons.
[]
Volume Allows you to adjust the volume of the video clips or
voice memos. You may set the volume level with the
[ ]/[ ] buttons.
Icon Item Option Functional Description
DC_P500_UM.book Page 21 Wednesday, August 17, 2005 8:23 AM
To Next Page
Loading...
