BenQ DC 5530 User’s Manual
English
Preparing Your DC P500 for Use 3
2 PREPARING YOUR DC P500 FOR USE
2.1 Installing the Battery
We highly recommend that you use only the specified
rechargeable lithium-ion battery for your camera. Make
sure that the power of the camera is off before inserting
or removing the battery.
To insert the battery:
1. Open the battery/SD memory card cover (A).
2. Insert the battery in the correct direction shown
(B).
3. Move the battery lock lever in the direction of the
arrow (C) to secure the battery.
4. Close the battery/SD memory card cover (D).
To remove the battery:
1. Open the battery/SD memory card cover.
2. Release the battery lock lever.
3. When the battery has come out a little, gently pull it
out the rest of the way.
2.2 Charging the Battery
The battery charge status affects the performance of the DC
P500. To maximize the performance and life of the battery, it
is recommended that you fully charge the battery using the
AC power adapter, and then fully discharge it through the
normal use at least one time. Make sure that the power of the
camera is off before inserting the battery.
1. Insert the conversion adapter into the conversion adapter
terminal of the camera as shown in the illustration.
2. Connect one end of the AC power adapter to the DC IN
terminal of the conversion adapter.
3. Connect the other end of the AC power adapter to a wall outlet.
The length of the charging time depends on the ambient temperature and the status of
the battery.
• The DC P500 must be used with the specified AC power adapter. Damage caused by the
use of an incorrect adapter is not covered under the warranty. Always make sure that the
camera is off before removing the battery.
• The battery may be warm after being charged or used. This is normal and not a malfunc-
tion.
A
B
C
D
DC_P500_UM.book Page 3 Wednesday, August 17, 2005 8:23 AM
To Next Page
Loading...
Need help?
General
