English
22
Connection
Connection
When connecting a signal source to the projector, be sure to:
1. Turn all equipment off before making any connections.
2. Use the correct signal cables for each source.
3. Ensure the cables are rmly inserted.
Smart devices
A/V device
PointWrite kit
Notebook or desktop computer
Mmontor
Touch module
(VGA) or (DVI)
Speaker
1. Audio cable
2. USB cable (A to micro B type): Connect to
PointWrite Touch module or connect to the
HDMI dongle for power supply
3. VGA cable
4. VGA to DVI-A cable
5. HDMI cable
6. USB cable
7. HDMI dongle (QCast Mirror, etc.)
• In the connections above, some cables may not be included with the projector (see "Shipping contents"
on page 10). They are commercially available from electronics stores.
• The connection illustrations are for reference only. The rear connecting jacks available on the projector
vary with each projector model.
• Many notebooks do not turn on their external video ports when connected to a projector. Usually a key
combo like FN + function key with a monitor symbol turns the external display on/off. Press FN and the
labeled function key simultaneously. Refer to your notebook's documentation to nd your notebook's
key combination.
• If the selected video image is not displayed after the projector is turned on and the correct video source
has been selected, check that the video source device is turned on and operating correctly. Also check
that the signal cables have been connected correctly.
To Next Page
Loading...
