BenQ LU950 - Command Table

8
Command table
 Available features differ by projector specification, input sources, settings, etc..
 Commands are working if the standby power is 0.5W or a supported baud rate of the projector is set.
 Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
 If a command format is illegal, it will echo Illegal format.
 If a command with correct format is not valid for the projector model, it will echo Unsupported item.
 If a command with correct format cannot be executed under certain condition, it will echo Block item.
 If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All the commands and
behaviors are identical with the control through a serial port.
Function
Type
Operation
ASCII
LU951
Power
Write
Power On
<CR>*pow=on#<CR>
YES
Write
Power off
<CR>*pow=off#<CR>
YES
Read
Power Status
<CR>*pow=?#<CR>
YES
Write
COMPUTER/YPbPr
<CR>*sour=RGB#<CR>
YES
Source Selection
Write
COMPUTER 2/YPbPr2
<CR>*sour=RGB2#<CR>
NO
Write
COMPUTER 3/YPbPr3
<CR>*sour=RGB3#<CR>
NO
Write
Component
<CR>*sour=ypbr#<CR>
NO
Write
Component2
<CR>*sour=ypbr2#<CR>
NO
Write
DVI-A
<CR>*sour=dviA#<CR>
NO
Write
DVI-D
<CR>*sour=dvid#<CR>
NO
Write
HDMI(MHL)
<CR>*sour=hdmi#<CR>
YES
Write
HDMI 2(MHL2)
<CR>*sour=hdmi2#<CR>
YES
Write
HDMI 3
<CR>*sour=hdmi3#<CR>
YES
Write
Composite
<CR>*sour=vid#<CR>
YES
Write
S-Video
<CR>*sour=svid#<CR>
YES
Write
Network
<CR>*sour=network#<CR>
NO
Write
USB Display
<CR>*sour=usbdisplay#<CR>
NO
Write
USB Reader
<CR>*sour=usbreader#<CR>
NO
Write
HDbaseT
<CR>*sour=hdbaset#<CR>
YES
Write
DisplayPort
<CR>*sour=dp#<CR>
NO
Write
3G-SDI
<CR>*sour=sdi#<CR>
NO