BenQ LX810STD - Page 49

Maintenance 49
Timing of replacing the light source
When the Light indicator lights up red or a message appears suggesting it is time to
replace the light source, please consult your dealer.
The following light source warning displays will remind you to change the light source.
"XXXX" shown in the above messages are numbers that vary depending on different models.
Replacing the light source
Do not replace the light source by yourself. Please contact a professional
dealer.
Status Message
We recommend that you install a new light
source for optimal performance.
Press MODE/ENTER to dismiss the message.
It is strongly recommended that you replace the
light source at this age. The light source is a
consumable item. The light source brightness
diminishes with use. This is normal light source
behavior. You can replace the light source
whenever you notice that the brightness level has
significantly diminished.
Press MODE/ENTER to dismiss the message.
The light source MUST be replaced when this
message appears.
Press MODE/ENTER to dismiss the message.
OK
Order a light source replacement service
Equivalent light source hour>XXXX Hours
Contact BenQ Service for additional information.
NOTICE
OK
NOTICE
Order a light source replacement service
Equivalent light source hour>XXXX Hours
Contact BenQ Service for additional information.
OK
NOTICE
Order a light source replacement service
Equivalent light source hour>XXXX Hours
Contact BenQ Service for additional information.
OK
Out of Light Source Usage Time
Contact BenQ Service for additional information.
WARNING