BenQ MP776 - Page 41

Operation 41
Controlling the projector remotely through a web browser
Controlling the projector remotely through a web browserControlling the projector remotely through a web browser
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
1. Enter the address of the projector in the address bar of your browser and click GO
GOGO
GO.
2. The remote network operation page opens. This page allows you to operate the
projector as if you were using the remote control or control panel on the projector.
i. These buttons function the same as the ones on the OSD menus or remote
control. See "2. PICTURE menu" on page 47 and "Remote control" on page 11 for
details.
The Menu button can also be used to go back to previous OSD menu, exit and save menu
settings.
ii. To switch input source, click on your desired signal.
The source list varies according to the connectors available on the projector. “HDMI 1” stands
for the HDMI signal; “Video 1” stands for the Video signal; “S-Video 1” stands for the S-Video
signal.
i
i
i
ii