Operation 47
Function Description
Standby
Settings
Network
Selecting On enables the function. The projector is able to provide the
network function when it is in standby mode.
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the COMPUTER jack is
correctly connected to devices. See "Connection" on page 16 for how
to make the connection.
Audio Pass Through
The projector can play sound when it is in standby mode and the
corresponding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. See "Connection" on page 16
for how to make the connection.
Enabling this function slightly increases the standby power consumption.
Network
Settings
See BenQ Network Projector Operation Guide for details.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, User 1, User 2, Color
Space Conversion, Language, Projector Installation, High Altitude
Mode, Security Settings, Baud Rate and Network Settings.
Current
System
Status
Source
Shows the current signal source.
Picture Mode
Shows the selected mode in the PICTURE menu.
Lamp Mode
Shows the current lamp mode.
Resolution
Shows the native resolution of the input signal.
3D Format
Shows the current 3D mode.
Color System
Shows the input system format.
Equivalent Lamp Hour
Displays the number of hours the lamp has been used.
Firmware Version
Shows the firmware version of your projector.
5. SYSTEM SETUP: Advanced menu
To Next Page
Loading...
