BenQ MX602 - User Manual

Questions and Answers

C
Christopher CochranAug 11, 2025
Why my BenQ Projector does not turn on?
- X
  xlambertAug 11, 2025
  If your BenQ Projector is not turning on, it could be due to the following reasons: * There's no power from the power cord. Make sure the power cord is plugged into the AC power jack on the projector and into a working power outlet. If the power outlet has a switch, ensure it is switched on. * You're attempting to turn the projector on again during the cooling process. Wait until the cooling down process has completed.
Q
qmahoneyAug 18, 2025
How to fix a BenQ Projector remote control that is not working?
- S
  Steven WashingtonAug 19, 2025
  If the remote control for your BenQ Projector isn't working, consider these possible causes: * The battery is out of power. Replace the battery with new ones. * There is an obstacle between the remote control and the projector. Remove the obstacle. * You are too far away from the projector. Move closer, standing within 8 meters (26 feet) of the projector.
H
hbakerAug 26, 2025
What to do if my BenQ MX602 Projector has no picture?
- T
  timothy57Aug 26, 2025
  If your BenQ Projector is not displaying a picture, there are several potential causes: * The video source might not be on or properly connected. Ensure the video source is turned on and the signal cable is correctly connected. * The projector may not be correctly connected to the input signal device. Check the connection. * The wrong input signal might be selected. Use the SOURCE key on the projector or remote control to select the correct input signal. * The lens cover might still be closed. Open the lens cover.
S
spencerdavidSep 2, 2025
How to fix a blurred image on a BenQ MX602?
- H
  Holly KeithSep 3, 2025
  If the image from your BenQ Projector appears blurred, here are a few things to check: * The projection lens is not correctly focused. Adjust the focus of the lens using the focus ring. * The projector and the screen are not aligned properly. Adjust the projection angle and direction, as well as the height of the projector if necessary. * The lens cover is still closed. Open the lens cover.