31 Menu operation
3D Mode
The default setting is Auto and the projector automatically chooses an
appropriate 3D format when detecting 3D contents. If the projector cannot
recognize the 3D format, manually choose a 3D mode according to your
preference.
When this function is enabled:
• The brightness level of the projected image decreases.
• The Picture Mode cannot be adjusted.
• The Vertical Keystone can only be adjusted within limited degrees.
The function is accessible through the remote control.
3D Sync Invert
When your 3D image is distorted, enable this function to switch between the
image for the left eye and the right eye for comfortable 3D viewing experience.
The function is accessible through the remote control.
Settings
Press OK to enter its submenu.
Press BACK to save your changes and exit.
See below for more details.
To Next Page
Loading...
