EN / BEP Smart Battery Hub User Installation Manual
Copyright
This document is copyright 2020 under the Creative Commons agreement. Rights are granted to research and
reproduce elements of this document for non-commercial purposes on the condition that BEP is credited as the
source. Electronic re-distribution of the document in any format is restricted, to maintain quality and version
control.
Important
BEP strives to ensure all information is correct at the time of printing. However, the company reserves the right to
change without notice any features and specifications of either its products or associated documentation.
Translations: In the event that there is a difference between a translation of this manual and the English version,
the English version should be considered the official version.
FCC Statement: This device complies with the limits for a Class B digital device, pursuant to part 15 of FCC
rules. These rules pertain to reasonable protection from harmful interference in a normal installation. This
equipment generates extremely low levels of radio frequency energy which should not interfere with normal radio
equipment if installed properly. If interference is detected and attributed to this device, you could try to:
• re-orient or relocate the receiving antenna
• separate the equipment and the receiver
• isolate circuit output between the device and the radio
• contact an experienced technician or dealer to help.
It is the owner’s sole responsibility to install and operate the device in a manner that will not cause accidents,
personal injury or property damage.
To Next Page
Loading...
