5
Main Features & Controls
3. 4.
1.
5.
7.
2.
6.
8.
9.
10.
11.
12.
13.
14.
1. On/Off Master Switch (located at rear left of unit)
2. Handpiece and Power Lead/Water Hose
3. Water Reservoir
4. Water Reservoir Cavity
5. LCD Display (indicates burr speed, direction and spray level)
6. On/Off Button for Handpiece Motor and Spray
7. Burr Rotation Speed Control
(if using a burr with a head diameter greater than 5mm,
DO NOT OPERATE THE HANDPIECE AT MORE THAN 10,000 RPM)
8. Spray Volume Setting Controls (Off, Low, Medium, High)
9. Burr Direction Control
(only change Burr Direction when hand-piece motor is not rotating)
10. Light On/Off Switch (feature not available in Australia)
11. Memory Buttons (M1, M2, M3)
12. Receiving Socket for Handpiece Hose/Power Lead
13. Handpiece Holster
14. Handpiece On/Off Button
Stand By Mode Button
Activates/de-activates both
Spray and Handpiece Motor.
Spray On/Off Button
Activates/de-activates
Water Spray.
Spray Volume Buttons
(3 Levels)
Adjusts level of Water Spray
(Low, Medium or High).
Memory Buttons
3 Programmable Memory Slots for Burr
Speed and Direction, and Spray Level.
Burr Speed Control Slide
Adjusts the burr speed from 4,000 to 40,000rpm.
Slide from left-to-right to increase speed.
Slide from right-to-left to decrease speed.
Touch Control Functions
M1 M2 M3
Burr Direction Button
Switches burr direction
clockwise/anti-clockwise.
To Next Page
Loading...
