6
LCD Screen Indicators
Burr Rotation Indicator
(Clockwise/Anti-clockwise)
Water Spray Level Indicator
(Low/Medium/High)
Lamp On/Off
(lamp not available in Australia)
Burr Speed Indicator
(3,000-40,000 rpm)
1 2 3
7000
rpm
Active Memory Indicator
a. Remove all components from the carton (please retain carton for return shipping if or when necessary).
b. Identify your preferred location for the white nylon Handpiece Cradle. Remove the protective cover from the
adhesive pad and secure the Cradle to the surface where you feel it will be appropriate for ease of insertion/removal
(we would suggest that the cradle should be mounted on a vertical surface, positioned in a way that the hand-piece
can be put into the retaining hole pointing approximately 45 degrees off vertical).
c. Connect the Handpiece Hose/Power Lead (2) into the Receiving Socket (12) at the front, lower right corner of the
Main Control Panel. Please note that the two copper spray lines fit into the two larger receiving holes at the bottom of
the Socket and the three power contacts are at the top of the socket.
Initial Set-up
The Handpiece on the Berchtold PodoS60 Spray Drill is designed NOT to be dismantled by anyone other than our Trained Technicians and
any dis-assembly by unauthorised persons will result in the Manufacturer’s Warranty being voided. If you consider that you are having any form
of problem with your Handpiece, please contact our Service Department immediately for further guidance.
From within Greater Melbourne please telephone: 8586 7800
From outside the Melbourne area please telephone: 1800 33 41 42
Handpiece Care
To Next Page
Loading...
