bergmann C301 - Operations, Charging, and Maintenance; Operating the C301; Stopping and Parking Brake; Battery Charging

4
GB - OPERATING INSTRUCTIONS & CHARGING - SERVICE & MAINTENANCE - ELECTRIC DUMPER
OPERATING INSTRUCTIONS
Check Baery Condion - Orange light charging Green light charged
E Stop out ignion on
1&2 Forward & Reverse Controls
3&4. Stopping and Park brake
ON INCLINES Do not use the C301 on inclines / ramps above 25°
Do Not travel forwards down inclines.
TO MOVE C301 Press yellow dead-man handle on right handle
down for any movement.
Right handle lower lever for forward moon.
RH & LH lower lever together for reverse moon.
TO STOP / PARK Release dead-man handle to stop.
Release lower forward / reverse levers.
Ideally Park on at surface.
OPERATING INSTRUCTIONS & CHARGING
Check mains lead is stored correctly and is secured to the machine.
Check mains lead is not damaged in any way and replace as necessary.
OPERATING THE C301
Pull out large red buon. (DEADMAN KILL SWITCH)
Turn ignion key on.
Depress dead man lever (RED) on right hand controls.
To Move Forward — squeeze right hand lever to move forward.
To Reverse — squeeze and hold le hand lever, then squeeze the right hand
lever to move the machine in reverse.
STOPPING THE C301
Release the right hand lever to stop the machine
Release the dead man red lever to engage the parking brake
In emergencies hit the large red buon (DEADMAN KILL SWITCH)
When machine is not in use, always push in the large red buon.
PARKING BRAKE - The Parking Brake operates automacally when the dead
man lever (RED) is in the upright posion. The brake is on unl the dead-man
(RED) lever is compressed to release it.
MOVING the C301 with NO POWER
For manual brake release when the machine has no power
Push brake release lever forward and hold the dead-man lever down, the C301
can now be moved manually.
CHARGING THE ELECTRIC C301
1. C301 has a built-in 24v charger
2. Turn o ignion switch.
3. Push in the large red buon.
4. Connect the cable provided to a mains supply 110-230 v. Charger is dual
voltage.
5. Check baeries are charging by observing small window on right- hand side
of baery box.
6. The CHARGING light is normally ORANGE which changes to GREEN when the
baery is fully charged.
7. The charger is a Smart Charger, it can be le connected to the baeries aer
full charge (green light) without harming baeries. The charger uses minimum
power in this stand-by mode (aer baery is fully charged), maintains the
baeries at full charge and extends baery life.
Machine Cleaning
Clean the machine aer it has been used to prevent the collecon of
hardened debris. Hardened debris is very dicult to remove. To clean it use
an old brush or hand brush with water. Never pressure wash or hose down
the electric motor housing. Clean only with a cloth or compressed air.
Lubricate the single grease nipple on the centre joint once a year.
Tyre Pressure
C301 tyre pressure should be regularly checked and
maintained at 25PSI (otaon and turf tyres).