Notices for the User
As of: 02/2009 - 7 -
Product Transfer Instructions
According to product liability requirements, the following listed points must be
checked.
Please mark applicable boxes.
Vehicle was checked against the delivery note. All individually packed parts have been
removed.
All safety equipment, PTO shafts and
control elements are present.
Operation, initial start-up and maintenance of the vehicle according to the
operating instructions has been addressed and explained to the customer.
Tires checked for proper air pressure.
Wheel nuts checked for tightness.
Instructed on proper PTO shaft RPM.
Mechanical functions demonstrated and explained.
Electrical connection to the tractor was made and the connection was
checked. Observe notices in the operating instructions!
Fitting to tractor carried out.
PTO shaft shortened to proper length.
Electrical system functions were checked and explained.
Hydraulic connection to the tractor was made and checked
checked for proper connection.
Hydraulic functions were demonstrated and explained.
Parking and service brake function tested.
Test run was made and no deficiencies were found.
Explanation of functions during test run.
Information about optional and extra equipment was provided.
Informed that reading the operating instructions is absolutely necessary
In order to prove that the vehicle and operating instructions were transferred properly, the transfer
statement must be filled out, signed and returned to Bergmann.
Maschinenfabrik
D – 49424 Goldenstedt, Hauptstrasse 64 - 66
Tel. 0444/2008-0 Telefax 04444/2008-88
To Next Page
