Bergstrom K312 - Cooling and Humidification Modes; Cooling Mode Operation; Humidification Mode Operation; Important Water Level Note

4L Air Cooler K312 Instructions for Use
Please read and retain these instructions for future reference v002: 08/12/21
· Change the ventilation speed with each press on the button SPEED: low, medium or high.
COOLING
The appliance can cool the air flow if cold water is added to the tank. Create additional cool air by placing a
freezer cooling element in the water in the water tank. The appliance is supplied with two cooling elements,
so you can use one and keep one in the freezer.
Caution: Only use this mode when the water tank is filled with fresh cold water.
· Turn the lock lever of the tank to a horizontal position and carefully pull the water tank out of the
appliance to fill it. Fill the water tank with fresh cold water and make sure that the water level in the
water tank does not exceed the maximum level (MAX).
· If you place a frozen cooling element in the water tank, make sure the water level does not exceed the
maximum level.
· Place the water tank back in the original position and turn the lock lever to the vertical position.
· Switch on the appliance using the ON/OFF key.
· The indicator light for the lowest speed lights up
· Press the mode key COOLER/HUMIDIFY. The indicator light cooler/humidify lights up red.
· Change the ventilation speed with each press on the button SPEED: low, medium or high.
Important
· Always use fresh cold water.
· Make sure the water in the water tank does not drop below the minimum level (MIN) when using the
cooling or air humidification mode.
HUMIDIFICATION
The appliance can humidify the indoor air and thus create a healthy living environment. For a healthy indoor
living climate, the air humidity should be between 40% and 60%. If the air humidity is lower, use the
appliance in humidify mode.
Caution: only use this mode when the water tank is provided with fresh cold water.
· Turn the lock lever of the tank to a horizontal position and carefully pull the water tank out of the
appliance to fill it. Fill the water tank with fresh cold water and make sure that the water level in the
water tank does not exceed the maximum level (MАХ).
· Place the water tank back in the original position and turn the lock lever to the vertical position.
· Switch on the appliance using the ON/OFF key.
· The indicator light for the lowest speed lights up.
· Press the mode key COOLER/HUMIDIFY 2 x. The indicator light cooler/humidify lights up blue.
· The speed of the ventilation cannot be changed when using this mode and is always at the lowest
speed.
Important
· Always use fresh cold water.
· Make sure the water in the water tank does not drop below the minimum level (MIN) when using the
cooling or air humidification mode.