Bergstrom M487 - Page 4

4
In DAB/FM mode, press to see the broadcast information
Rec
Press to active encoding/Mp3 file copy function
In encoding mode: press to active track separation function
Precautions for use
Installation
• Unpack all parts and remove protecve material.
• Do not connect the unit to the mains before checking the main voltage and before all other
connecons have been made.
• Do not cover any vents and make sure that there is a space of several cenmeters around
the unit for venlaon.
Connecon
1. Connect the speaker plug of each speaker to the speaker sockets (L/R, 32).
2. Also, connect the provided DAB/FM antenna to the antenna socket (30).
3. Plug in the AC cord (33) to a 230V AC Mains outlet. The LCD screen (2) will light up dimly
and the Red Standby LED indicator will also light up (5.)
4. Press the On/Standby buon (6.) to switch the unit on and now brightly lit blue LCD
display. Your music system is now ready for use.
Setting the clock
1. Set unit in standby mode.
2. Press and hold the “Mem/Clk-Adj” button (12) until display will flash “24HR”. press the
Skip Up or Skip Down button (23/13) to select the clock format between 12 or
24Hour. Then press the “Mem/Clk-Adj” button (12).
3. The first digit of “0:00” is flashing on the LCD display (2). Press Skip Up or Skip Down
button (23/13) to set the correct hour. Press “Mem/Clk-Adj” button (12) to store the
correct hour.
4. The third & fourth digit of “00” is flashing; press the Skip Up or Skip Down button
(23/13) to set the correct minutes. Then press “Preset/Clk-Adj” button (12) to store the
correct minute.
➢ The clock seng mode will automacally quit if no buon is being pressed in a period
of about 5 seconds aer pressing the “Mem/Clk-Adj” buon.
➢ The pre-set me will be re-set completely if dis-connecng the main power supply.
You are recommended to switch the system into standby mode for convenience usage.
Listening to FM radio
Before operation, please ensure the DAB/FM tuner antenna has been connected to the
antenna socket (30).
Manual tuning
1. Switch on the unit by pressing the On/Standby buon (6), then press Funcon buon (10)
to select “ DAB ” mode then press Band buon (16) to select FM mode.
2. Tune to the required staon by pressing the Tuning Up or Down buon (23/13).
3. Turn the Volume knob (19) to the desired volume level.