Bergstrom M487 - Page 5

5
Auto tuning (on the remote control only)
1. Set the unit to FM mode.
2. Press the Scan buon once on the remote control; unit will start to scan at tuning up direct
unl radio staon received. Press and hold the Scan buon on the remote control for a
second, the unit will scan to tuning down direcon. If the radio data system (RDS)
broadcasng signal received, the unit will set the actual me automacally.
3. Turn the Volume knob (19) to the desired volume level.
Radio data system (RDS)
This is the features to display the informaon which released from the radio broadcast and
will showed on LCD display step by step as below by pressing the Info buon (on the remote
control) connuously.
Radio text → program type → signal strength → date/me → frequency → mono/stereo
Digital audio broadcasng (DAB) radio
1. Set the unit to “DAB” mode by Funcon buon (10).
2. Press the Scan buon on the remote control once; unit will start to full scan from range
11b-12d one me within around 2 seconds. Then press Tune up/down buon (23/13) to
select your desired DAB channel.
3. Press the Info buon connuously to check the below info released by DAB.
Group name → frequency → transfer rate → signal strength → date/me → program
type → scrolling text
4. Press the Volume knob (19) to the desired volume level.
Preset stations
You can store up to total of 40 radio staons in the memory (20-FM/20-DAB).
1. Set to FM/DAB mode
2. Turn to the desired radio staon by “manual” or “auto” tuning method.
3. Press and hold the Mem/Clock-Adjust buon (12) around four seconds to enable memory
state, the preset staon will ash on LCD display.
4. Preset the Folder/ Pre up buon (22) to select the desired staon memory for storage.
5. Press Mem/Clock-Adjust buon (12) to conrm the preset memory.
6. Repeat step 2 to 5 to store other staons.
Recall preset stations
1. Press the Mem/Clock-Adjust buon (12) once to enable recall state
2. Press Folder/ Pre up buon (22) to select the desired memory staon.
3. Press Memory/Clock-Adjust buon (12) to conrm the recall memory staon.
➢ The pre-set memories will be cancelled completely if dis-connecng the main power
supply and back up baery did not installed. You are recommended to switch the system
into standby mode for convenience usage.
➢ There are 3 seconds for program state, aer 3 sec, this state would resume to normal tuner
mode automacally.
➢ You can overwrite a present staon by storing another frequency in its place.
FM-Stereo reception
⚫ Press the “Enter” knob (3) repeatedly; the FM programs are receiving in mono and stereo