Bergstrom M487 - Page 9

9
Playback of MP3 song via USB storage media
Connecting
The system is able to decode and playback all MP3 file which stored in the
memory media with USB connecting port
1. Set the system at standby mode first or other function except USB
mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into
completely
⚫ Connecng the USB upside down or backwards could damage the audio system or the
storage media (USB thumb drive). Check to be sure the direcon is correct before
connecon.
3. Set Funcon buon (10) to USB mode.
4. The system will start reading the storage media automacally aer connecng, and LCD
display (2) will show the total number of MP3 les being detected.
5. Repeat the same playback procedure and programming as playing CD disc as above.
Remark
- The system can detect and read the le under MP3 format only at USB mode but no other
music le format.
- If connect the system to MP3 player via the USB socket, due to variances in MP3
encoding format, some MP3 player may not be able to play via the USB socket. This is
not a malfuncon of the system.
- USB port does not support connecon with USB extension cable and is not designed for
communicaon with computer directly
Removing of USB
To remove the USB, turn o the power or switch the funcon mode to either CD, aux or tuner
rst. Un-plug the USB by pulling out directly.
Encoding into MP3 file
The system is able to encode normal CD/Tuner/Phono or cassee tape le to MP3 format and
recording at memory media with USB connecng port. The system will create a music folder
name – “ RIP” for CD-DA encode, “REC” for Tuner, Aux, Cassee encode and “FROMCD” for
CD-MP3 disc copy and encode bitrate default at 128kbps.
A) CD encoding
I) encoding 1 track / 1 disc at 1x speed
1. Perform normal playback of the CD track you want to encode & record,
2. Press “ ” buon (4) during the playback of the desire track and the display will show
“REC” and “USB” ashing.
3. Press “ ” buon (4) again the display will show “REC” and “ONE” ashing.
4. Press “ ” buon (4) again, the system will ashing with “REC USB” icon. Encoding is
performing now.
5. Aer compleng of recording, unit will stop playback automacally.
6. Press “stop ” buon (3) to interrupt the recording mode anyme.
7. For encode whole CD track, please stay CD in stop mode then press “ ” buon (4)
three mes unl the display ashing “REC USB”, then system will start to playback CD and
encoding whole disc.
Remark:-
- The recording speed is 1:1 and according to the actual plying me of the CD track
- The recording format is preset at – MP3 bit rate: 128 kbps, sampling rate: 44.1khz
- Press “ stop ” buon (3) to interrupt the recording mode at any me.