Bering BEXP20i - Display Settings and Parameters; Lock;Unlock Display Function; Water Temperature Setting; Parameter Checking

29
7.4.3 and button
Lock / Unlock the display:
Hold and for 5 seconds to lock/unlock the display.
Water temperature setting:
Press or to set the water temperature directly.
Parameter checking:
Press first, then press to check the “ User parameter from d0 to d11
Code
Condition
Scope
Remark
d0
IPM mould temperature
0-120℃
Real testing value
d1
Inlet water temp.
-9℃～99℃
Real testing value
d2
Outlet water temp.
-9℃～99℃
Real testing value
d3
Ambient temp.
-30℃～70℃
Real testing value
d4
Frequency limitation code
0,1,2,4,8,16
Real testing value
d5
Piping temp.
-30℃～70℃
Real testing value
d6
Gas Dischargetemperature
0℃～C5℃ (125℃)
Real testing value
d7
Step of EEV
0～99
N*5
d8
Compressor running frequency
0～99Hz
Real testing value
d9
Compressor current
0～30A
Real testing value
d10
Current fan speed
0-1200 （rpm）
Real testing value
d11
Error code for last time
All error code
Remark: d4: Frequency limitation code, 0: No frequency limit,
1: Coil pipe temperature limit, 2: Overheating or overcooling frequency limit,
4: Drive Current frequency limit, 8: Drive voltage frequency limit,
16: Drive high temperature frequency limit.