E-222 OWNER/OPERATOR M ANUAL • 5
INSTALLATION
SITE S ELECTION
Select a solid, level surface to install the E-222 chopper. This area should be well lit and large
enough to allow easy access to all sides of the machine.
ELECTRICAL
Your E-222 chopper is manufactured with a 20-amp power cord and plug. Contact a licensed elec-
trician to install a 20-amp outlet. Do not try to modify a standard outlet to accommodate this plug.
Failure to use a correct outlet will void the warranty. Also, check that the line voltage matches the
motor specifications as shown on the serial plate.
APPROVED U SES
The Berkel E-222 chopper is suitable to cut and chop the following products:
• Meat
• Poultry
• Fish
NON-APPROVED U SES:
The Berkel E-222 chopper is not designed to cut and chop the following products:
• Non-food products
• Dry products
• Meat with bones
TESTING PRIOR TO OPERATION
1. Make sure the chopper is unplugged and is on a solid, level surface.
2. Check that the line voltage at the outlet matches the machine specifications.
3. Choose a knife and plate to install. (If you have just removed the chopper from its shipping
carton, it is greased and ready to run with a 1/8” plate from the factory.) The standard plate has
1/8” (3.2mm) holes. Optional plates are 3/16” (4.8mm), ¼” (6.3mm), and 3/8” (9.5mm). It is
recommended that a plate and knife should be matched and kept as a pair. They will wear evenly
and provide the best operation of the chopper.
CAUTION
Mixing knives and plates will cause them to
wear unevenly and possibly damage each other.
To Next Page
Loading...