MAINTENANCE
• Before carrying out maintenance opera-
tion please always switch off device and
unplug it.
•
Good, regular maintenance will extend
durability and improve cutting perform-
ance of your brush cutter.
• Regularly check fast and correct seat of
cutting tools and if necessary adjust them
again.
• Check correct seating off all screws every
10 operating hours. Loose screws ought
to be fastened again.
• Remove dirt and debris from engine.
• Check cylinder plate and air filter for
blockage and if necessary remove stick-
ing dirt, debris and so on.
• Carefully remove dirt and debris from
muffler and petrol tank.
• Check for loose or missing screws or
parts. Make sure that cutting tool is free
from debris and correctly mounted.
Page 8
Handhold:
• Loosen 4 screws of handle bracket.
• Insert right and left handle unit into
bracket and fasten screws again.
Fibre -/ blade protection:
• Mount protective cover to the gear head
and fasten it with help of the screws in-
cluded in delivery.
Speed Bowden cable:
• Remove air filter cover.
• Insert Bowden cable through adjusting
screw and fit end of Bowden control into
opening of throttle of carburettor.
• Adjust Bowden cable with help of adjust-
ing screw with 1-2mm clearance.
Assembling cutting knifes
• Loosen mounting nut on arbour of gear
head. Attention, Pay attention to left-hand
thread!
• Remove pressure plate cover and lower
pressure plate.
• Install cutting knife now and mount pres-
sure plate again.
• Tighten fastening screw again.
• Attached to upper pressure plate you will
find arrester bore. Insert e.g. hex wrench
to hold up screw and tighten fastening
screw by using a fitting wrench.
Assembling nylon cutter:
• Loosen fastening nut on arbour of gear
head, pay attention to left-hand thread!
• Only remove pressure plate cover.
• Screw nylon cutter on top of thread.
• Attached to upper pressure plate you will
find arrester bore. Insert e.g. hex wrench
to hold up screw and fasten nylon cutter
by hand.
Page 5
• On mowing please protect yourself suffi-
ciently with protective cloth such as ear
protection, safety boots, tight-fitting cloth,
Helmet, safety gloves and protective gog-
gles.
• While working with this machine please do
never wear any jewels as these could be
caught in moving parts and cause bad
injuries.
• On starting brush cutter it may not touch
any objects.
• Make sure that device is not defective or
incompletely or incorrectly mounted. In
that case please do not operate brush
cutter.
• Before putting brush cutter down please
switch it off.
• Handles of brush cutter should always be
dry, clean and not contain any remains of
petrol or oil.
• Never operate brush cutter when you are
tired, have drunk alcohol or taken any
other drugs.
• On cutting you should always work with a
high engine speed.
• Also pay attention to the maintenance
information given by manufacturer and do
only use approved original spare parts.
• Important: When working with cutting
blade always remove fibre head from
protective cover. But anyway never oper-
ate device without protective cover.
• Attention! Sound pressure level given on
this item is only a measured reference
value. As it is very much depending on
operating environment it can vary in
every days use. Protect yourself and
other people according to the given val-
ues adequate from developing noise
exposure.
To Next Page
Loading...