RED LIGHT on with buzzing: Telling the connection is wrong, and buzzing to alarm to correct the
clamps as step 2 mentioned above, wait until the GREEN LIGHT is on to turn on the engine.
GREEN LIGHT blinking with buzzing: Saying the vehicle battery is low, press the “BOOST” button,
wait GREEN LIGHT becomes solid, then turn on the engine within 30s.
Note : When Boost button is pressed, booster works without any protection
No Lights on, No buzzing: Saying the vehicle's battery maybe damaged, after confirm the clamps
connection is correct, press the “BOOST” button, wait GREEN LIGHT is on, and then turn on the
engine within 30s.
4.Start the vehicle.
5. As soon as the vehicle is started, remove the jumper cable from the vehicle battery. Leave the
vehicle's engine running.
Charging Cell Phone or Tablet Instruction:
1. Plug the switch cable B to USB 5V 2A output port.
2. Select appropriate connector and connect it to your mobile phones or tablet.
3. Press the switch button to charge.
Only for charging/power supply to 19V Notebook
1. Plug the switch cable A to USB 19V 3.5A output port.
2. Select appropriate connector for your Notebook and connect it to the switch cable A and your
Notebook.
3. Press the switch button to charge/power supply.
To Next Page
Loading...