en- 25
*depending on the equiment variant
3
8.4 Insert PE emptying and disposal bag
NOTE
Operating the rotary slide
▶ Turn the red rotary slide inside to position OPEN to the stop
on the marker ▲.
▶ Slide the ange completely over the intake socket.
▶ Place the upper bag opening over the container rim.
3
9 Changing the lter
9.1 Changing the folding lter
(See short-form instructions )
▶ Shake the folding lter cassettes before changing them.
▶ Turn the lock on the latch through 90° in a counter-clockwise
direction with a coin or similar object and push the latch to the
rear.
▶ Fold the hood up
▶ Immediately isolate the folding lter cassettes that you have
removed in a dust-tight plastic bag and dispose of properly in
accordance with the stipulations.
▶ Insert new folding lter cassettes.
▶ Lift the locking bracket up, fold the hood down and click in place
with light pressure.
10 Changing the motor protection lter
(see Quick Reference Guide ).
NOTE
If motor protection lter is contaminated, this indicates defective
lter cartridges.
▶ Replace folded lter cartridges.
▶ Replace motor protection lter or wash the motor protection
lter under owing water, dry and re-insert.
11 Transport
▶ Remove suction hose.
▶ Close off intake socket with cap.
▶ Securely x the motor head to the container (close the side
latches).
▶ Place the accessories in a suitable plastic bag and seal the plas-
tic bag or place it in the tool storage compartment.
▶ Put the suction hose ends together so that no dirt particles leak
out.
▶ Place the hose around the vacuum cleaner and clamp onto the
handle (see Quick Reference Guide).
12 Maintenance
NOTE
Switch off the vacuum cleaner and pull out the mains plug before
carrying out any maintenance work.
For maintenance by the user, the vacuum cleaner must be
- dismantled,
- cleanded and
- maintained,
as far as possible without creating any danger to the maintenance
personnel or other.
Precautionary measures
Suitable precautionary measures include:
- Cleaning before dismantling
- Provision of local ltered positive ventilation where the vacuum
cleaner is to be dismantled
- Cleaning of the maintenance area
- Suitable personal protection equipment
PERM
To Next Page
Loading...
Need help?
General
