Bernette 715 - Page 17

Irgirting the bdbbin
When insehing ar raitiDving lh& iMb-
Chh. lh& noodle must be fully rais«<J.
Open th^ hinged
Hold ihe bobt}in caso with on-e hand,
Insen Ihe bobbin so 1tiat Ihe Ihread
runs in a clockwise direction (arrowj.
( 2 )
PuJI lh& thread Ihnough the slit and
under the finiger. (3}
Hold the bobbn case by (he hinged
letch. (4)
Insert rl into the shuttle. (5)
Note:
The bobbin ihread tension
does not normally ha^o lo be ;
adjusted. |
_t
AttertU'orf:
Turn f>£>w 0 r swilch te ’0".
Bobbin fhreed len$ion
To test the bobbin Ihr&ad lansionH
remove the bobbin case and bobbin
and hold it by suspending it by the
thread. Jerk ii gnoe or twioe. If the
lansion is conroct, the thread will un¬
wind by about an inch or two. II the
tension is tocnight, it does not unwind
al all- tf the lension is loo loose, it will
drop loo much. Tp adjust, turn the
smaM screw on the skfeoJ Ihe bobbin
case, (&)