9
BLADE RITE 1750 MANUAL
© Bernhard and Company Limited
4.1 Switch on the grinding motor and apply a light cut. Traverse the length of the blade
manually without touching the l/h stop or allowing the blade to index. Check that the
width/angle of cut is constant along the blade length. Adjust the side arm handwheels, if
necessary, to achieve this.
4.2 Apply a reasonable cut and engage the traverse.
4.3 Increase the feed as necessary to keep the cut on each blade constant.
4.4 Finish the nal rotation of the reel with a light cut so that grindstone wear does not effect
the relative amount of metal removed from each blade.
4.5 Disengage the traverse and switch off vacuum and grinder, traverse and reel drive motors.
4. Relief Grinding (Blade Thinning)
To Next Page
Loading...
