Bernina 900 - Buttonholes with Reinforcing Cord; Fine Adjustment for Buttonhole Density; Reinforcing Cord Application

Buttonhole
with
Reinforcing
Cord
-TI
t
S22
Fine
adjustment
for buttonhole
To
ensure that
the buttonhole
is subsequently
reinforced
The stitch
density can
be adapted
very
where the
button pulls,
bythe
loopof the
inserted
cord, always
easily to the
material
by means
of knob
introduce
the work
so that the
edge of
the material
lies in front
(22)
It is recommended
to sew
a trial
of the presser
foot.
buttonhole
on a scrap
of the
same fabric
to
be
used.
1.
Engage
buttonhole
device.
Move
needle
downwards
to
foot
level, to check that
it comes in the middle
of the foot
opening.
If not do one stitch
by hand, but never change
zigzag or needle
position. Bring
work underneath
foot
and put
needle down
exactly
at the
beginning
of button-
hole
(inner
end). Do
not lower
the foot
yet.
2. Place
inserted
cord above
the middle
bridge on the
presser
foot and pull both ends under the foot to the rear. Do not
hold cord,
as this prevents
work
from feeding
through.
18