Bernina 900 - Darning with Wool; Darning Woollens and Terry Cloth; Applying the Wool (1 st Run); Oversewing Threads (2 nd Run)

Darning with wool
1st run: Applying the wool
... .. -.... Start the work on the left, a little above-\,
.
the hole Stitch down the wool with one -
or two stitches, and leave the needle
<--- down
Hold the area to be mended correctly.-/
p -'&---i >' t' < Do not push the work to and fro on the
machine, but hold it taut while you
.......................... ... - guide. Whenapplyingthewoolbearthe
- ' - .... following points in mind:
....... .. ..
...... ..
W rong way
to hold work
Darning
woollens
and
-
-
Do
not
make
too
deep
a
curve
at
the
Terry cloth (towels) ends or the threads will be too far
apart.
- Apply
the wool
threads close
toge-
---
ther over
the hole
(they may
even lie
K
1
slightly
over
one
another).
Always
move work sideways (left to right and / ,- •
vice
versa).
Thread machine with matching thread. ,,)
Lay the wool in the slot of the presser
- ..
foot. The wool will then be guided auto- -.
matically .
2nd run: Oversewing the threads
Cut
the wool
at the presser
foot.
Hold
work again as before. Now sew across ..... .
the new wool threads with zigzag The Correct way to hold work
zigzag rows should
not overlap nor lie
apart
from
one
another.
23