EN
32
10 12 15
Attention:
Turn power switch to "O" before inserting or
removing the needle.
Change the needle regularly, especially
if it is showing signs of wear and causing
problems.
Insert the needle as illustrated:
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle. (1)
B. The at side of the shaft should be
towards the back.
C/D.Insert the needle as far up as it will go.
Needles must be in perfect condition. (2)
Problems can occur with:
A. Bent needles
B. Blunt needles
C. Damaged points
Inserting the needle
To Next Page
Loading...
