Bernini Be42 - Page 7

Be42 OEM's Manual V5.0.XX - December - 2010 page 7
7
Display Function
Display indications (*)
Pushbutton(s)
Menu & Led indicator
Current of the Generator
(0 up to 2000A)
[XXXX] Ampere
[←F8] or [F9→]
Aac
menu
Yellow
[A -G]
[ACK-F10]
Voltage of the Generator
(60V up to 998V)
[GXXX] Volt L1-L2
[←F8] or [F9→]
Vac
menu
Yellow
[U -G]
[ACK-F10]
Voltage of the Mains
(60V up to 998V). If the
Mains is simulated, see
option [15] in table 7.07,
the display will show the
message [n-on]
[nXXX] (VL1-2)
[-XXX] (V L2-3)
[_XXX] (L1-L3)
[←F8] or [F9→]
[U -on]
[ACK-F10]
Generator Frequency
(20Hz up to 70Hz)
[GXXX] Hz
[←F8] or [F9→]
Hz/RPM
menu
Yellow
[H - G]
[ACK-F10]
Mains Frequency
(20Hz up to 70Hz)
[nXXX] Hz
[←F8] or [F9→]
[H - n]
[ACK-F10]
Speed
(600RPM up to 4000RPM)
[XXXX] RPM
[←F8] or [F9→]
Hz/RPM
menu
Yellow
(blinks)
[SPd]
[ACK-F10]
Battery Voltage
(5.5 Vdc up to 36Vdc)
[bXX.X] Vdc
[←F8] or [F9→]
Engine
Yellow
[batt]
[ACK-F10]
Charger Voltage
(3.0 Vdc up to 36Vdc)
[cXX.X] Vdc
[←F8] or [F9→]
[Char.]
[ACK-F10]
Oil Pressure 0.0-20.0 Bar
[PXX.X] Bar
[←F8] or [F9→]
[ bar ]
[ACK]
Temperature 0°-250 °C
[XXX °] °C
[←F8] or [F9→]
[ °C ]
[ACK]
Fuel Level % 0% - 99%
[F XX] %
[←F8] or [F9→]
[FUEL]
[ACK-F10]
Hours-count
(0 up to 9999h)
[XXXX] h
[←F8] or [F9→]
h/Prog
menu
Yellow
[Hour]
[ACK-F10]
Miscellaneous modes
(see sections 6.0,12.0 and 13.0)
[ProG] [-Cal] [tEst]
[←F8] or [F9→]
Yellow
(blinks)
OFF
[ .]
[OFF-F7]
OFF
OFF
(*)NOTE: X indicates a numerical digit, if the measurement is out of range, the display will indicate [- - - -]