SAVE THESE INSTRUCTIONS
COMPONENTS
ASSEMBLY
STEP 2STEP 1
1. Make sure valve is OFF by turning knob in direction of arrow until hand tight only. Do not Force.
2. Turn fuel cylinder clockwise into valve body until hand tight.
Do not Force. LIGHTING AND OPERATION
LIGHTING AND OPERATION
1. To light with a match, hold as shown and open valve slowly.
2. To light with spark lighter, open valve slowly before sparking.
Hold spark lighter at a 45° angle to the torch opening.
NOTE: It is very difficult to light with valve fully open.
3. For hottest, most efficient flame, adjust inner blue flame of pencil
burner to 1-1/2 to 2 inch length.
4. If ignition does not occur immediately upon opening the torch valve,
close the valve and wait 5 minutes before attempting to ignite again.
Failure to follow this instruction could result in a build up of flammable
gas which if ignited could result in a fireball that could cause injuries
and property damage. Do not open the valve and allow gas to flow
through the torch without attempting to ignite the torch.
ADDITIONAL WARNINGS
• Make sure torch is cool before tightening or removing burner head, or before installing or removing accessories.
• Check all joints and couplings periodically to insure against loose connections. With valve open, without lighting, test all
connections with soapy water. If bubbles appear, gas is leaking and torch must be repaired. Never Use a flame to check
for leaks. Make this test in a well-ventilated and spark-free area, and where there are no open flames.
• In cold weather the size of the flame will be smaller. To produce a larger flame, pre-warm the cylinder to room
temperature prior to use.
• ADDITIONAL NOTE: As a safety feature, the burner may snap if the torch is dropped, in which case the burner must be
replaced.
STORAGE
REMOVE CYLINDER FROM TORCH WHEN NOT IN USE
1. Turn valve off.
2. When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children.
Observe cautions on cylinder label.
Check out the collection of welding equipment & soldering tools we offer.
To Previous Page
Loading...
