Bertazzoni P604I1B26NV - Failure Display and Inspection; Technical Specifications

16
Failure Display and Inspection
If a fault occurs, the induction hob will enter the protection state automatically and display
the corresponding error codes:
.
The above are causes and solutions of the most common failures.
Do not disassemble the unit by yourself to avoid any hazards and damage to the induction
hob, and
please contact the supplier.
Technical Specifications
Cooking Zones
4 Zones
Supply Voltage
220–240V~
Installed Electric Power
7000 W (230V)
Product Size LxWxH (mm)
590x520x60
Building-in Dimensions AxB (mm)
560X490
Weight
and Dimensions are approximate. We continually strive to improve our products, so we
may change specifications and designs without prior notice.
Error Message
Possible Cause
What to do
No pan or pan unsuitable;
Replace the pan:
ER03
Water or pan on the glass over the control
Clean the user interface
F1E
The connection between the display board and the
left mainboard has failed (in the cooking zone for which
the indicator is showing “E”)
1. Connection cable not plugged in properly or
defective;
Replace the mainboard.
F3E
Coil temperature sensor failure. (in the cooking zone for
which the indicator is showing "E" )
Replace the coil sensor
F4E
Mainboard temperature sensor failure. (in the cooking
zone for which the indicator is showing "E" )
Replace the mainboard
E1E
Temperature sensor of the ceramic glass plate is high
Please restart after the induction hob has cooled
down.
E2 E
Temperature sensor of the IGBT is high
Please restart after the induction hob has cooled
down.
E3 E
Abnormal supply voltage (too high)
Please check that the power supply is normal;
Power on when the power supply is normal.
E4 E
Abnormal supply voltage (too low)
Please check that the power supply is normal;
Power on when the power supply is normal.
E5 E
Temperature sensor failure (in the cooking zone for
which the indicator is showing “E”)
Connection cable not plugged in properly or
defective assembly;