Need help?Do you have a question about the BESAFE IZI UP and is the answer not in the manual?
Details product group, weight, age range, and ECE R44/04 approval.
Indicates country of approval (GB) and ECE type approval number (E4 04443713).
Emphasizes reading the manual before installation to avoid endangering the child.
States compliance with the highest safety requirements for child safety.
Describes how headrest and backrest adjust automatically with head rest height.
Explains the seat's sleeping position feature and guaranteed safety.
Prohibits moving the seat upright while the child is seated, unless they get up.
Only install with a 3-point-belt approved to UN/ECE regulation No. 16 or equivalent.
Specifies that forward-facing installation is the only allowed method.
Only forward-facing installation is permitted; use with a 3-point-belt.
Advised car positions are indicated green, typically on the rear seat.
Advises against buying or selling second-hand seats due to potential danger.
Recommended not to use on a passenger seat with an activated frontal airbag.
Only use with a 3-point-belt approved to UN/ECE regulation No. 16 or equivalent.
Illustrates correct (3-point) and incorrect (2-point) belt usage for safety.
Identifies crucial parts: Head rest, cover, back rest, seat, and handle (1-7).
Identifies crucial parts: Shoulder belt guide, base, handle, manual storage, and knob (8-12).
Only use with a 3-point-belt approved to UN/ECE regulation No. 16 or equivalent.
Ensure the seatbelt is not twisted during installation for proper function.
The lap belt should be worn correctly over the hips for child safety.
Place the iZi Up on the car seat, ensuring contact with the seat back support.
Allow the child to take their place in the iZi Up for proper seating.
Adjust seat height using the height adjusting knob (11) for 6 positions.
Open shoulder belt guide (8), slide lower part outwards, and place belt inside.
Ensure belt is not twisted and close the shoulder belt guide (8).
Ensure belt runs straight over shoulder, level with child's shoulders, and lap belt over hips.
Lock belt in buckle and remove slack by pulling belt towards the retractor.
Ensure the seatbelt is correctly positioned within the designated green zone for safety.
Move sleeping positioning handle (7) upwards to engage the sleeping position.
Handle (7) automatically returns to neutral; seat returns upright when child exits.
An unoccupied iZi Up must remain fastened with the 3-point-belt.
Ensure luggage and other objects are properly secured in the vehicle.
Steps to remove: unlock belt, open guide, remove belt, close guide, then remove seat.
The cover is a safety feature; never use the iZi Up without it.
Refitting is done in the reverse order of removal for correct assembly.
Instructions for removing the back rest cover using Velcro, loops, and elastic edges.
Instructions for removing the head rest cover using fixing hooks (e & f) and elastic edges.
Instructions for removing the seat cover using fixing hooks (h & i) and elastic edges.
Refit the cover following the removal instructions in reverse order.
Wash the cover according to the instructions found on the inside of the cover.
Clean by hand with water and mild soap; avoid aggressive cleaning products.
BeSafe products are designed, manufactured, and tested by independent institutes.
Return faulty products within 24 months to the place of purchase for warranty consideration.
Valid only with proper use and care; expires with no receipt or due to misuse.
Illustrates incorrect headrest height (too high/low) versus correct height.
Shows incorrect belt installation compared to correct belt installation for safety.
Ensure the 3-point-belt is firmly tightened to prevent dislocation; check frequently.
Do not use cushions or coats to raise the seat, as it compromises protection.
Recommended not to use on a passenger seat with an activated frontal airbag.
All passengers must be fastened by a safety belt for safety.
Ensure passengers know how to release the child in an emergency.
Make sure luggage or other objects are properly secured to prevent injury.
An unoccupied iZi Up should still be fastened to the vehicle seat.
Ensure the iZi Up does not become trapped by a movable seat or door.
Keep this user manual in the storage compartment on the back of the seat.
Warranty will expire if non-original parts or accessories are used.
Never leave your child unattended in the iZi Up.
The cover is a safety feature. Never use the iZi Up without it.
The cover of the iZi Up should be washed in accordance with the instructions.
Do not use aggressive cleaning products; they may harm the construction material.
Do not use the iZi Up at home; it is a car safety product.
Recommend using a BeSafe protection cover to prevent damage to car interiors.
This is a 'Universal' restraint, approved for general vehicle use per regulation No. 44.04.
A correct fit is likely if the vehicle handbook declares acceptance of 'Universal' restraints.
Classified as 'Universal' under more stringent conditions than earlier designs.
If in doubt about fit or use, consult either the child restraint manufacturer or the retailer.
Only suitable if vehicles are fitted with 3-point-belts approved to UN/ECE Regulation No. 16.
To Next Page
General