Need help?Do you have a question about the BEST ACCESS SYSTEMS V Series and is the answer not in the manual?
General| Brand | BEST ACCESS SYSTEMS |
|---|---|
| Model | V Series |
| Category | Locks |
| Language | English |
Overview of the V Series Service Manual content and its purpose.
Lists compliance standards for HV and KV Locks.
Lists available documentation for the V Series system.
Information on obtaining assistance and support services.
Exploded view of the 8KV/9KV magnetic stripe trim components.
List of parts for the 8KV/9KV magnetic stripe trim.
Exploded view of the 34/35HV magnetic stripe trim components.
List of parts for the 34/35HV magnetic stripe trim.
Exploded view of the XV Controller components.
Illustrates special tools used for maintenance.
Describes operation of latchbolt, deadbolt, and levers for HV locks.
Describes operation of latchbolt, levers for KV locks.
Details parts needed to convert HV lock readers.
Details parts needed to convert KV lock readers.
Instructions and indicators for replacing the battery pack.
Steps for removing and reinstalling lock trim.
Procedure for replacing the internal circuit board.
Guide for replacing the Programmable Read-Only Memory (PROM).
Procedures for emergency access and troubleshooting.
Steps to open a lock with a dead battery.
Table of common lock problems and solutions.
Table of common controller problems and solutions.
Diagnosing and resolving alarm issues.
General overview of lockset installation procedures.
Guidance on using the positioning template for door preparation.
Steps for removing the external knob or lever.
Instructions for connecting internal and external wiring.
Procedures for testing lock functionality after installation.
General overview of lockset installation procedures.
Steps for marking door centerlines for installation.
Instructions for drilling necessary holes in the door.
Guidance on connecting wiring harnesses.
Procedures for testing lock operation post-installation.
General overview of controller installation.
Steps for unpacking and preparing the controller enclosure.
Details on connecting readers, locks, and other devices.
Final steps for completing the controller installation.
Methods for programming the controller via terminal or PC.
To Next Page
