How to reset the 'Replace Battery' alarm on a Best Power UPS?
If the green LINE LED is on, the yellow WARNING LED is on, and the UPS beeps three times every ten seconds, it means the unit has failed the battery test. Turn the unit off and then on to reset the “Replace Battery” alarm and LEDs.
What to do if the Yellow OVERLOAD LED is blinking and the Best Power UPS beeps every second?
If the yellow OVERLOAD LED is blinking and the UPS beeps every second, it means the power required by the connected equipment is too high. You should remove some of the connected equipment or reduce the load until the beeping stops.
Why is the yellow BATTERY LED on, the green LINE LED off, and the Best Power UPS beeping every 10 seconds?
This indicates a utility power outage, a loose plug, a tripped circuit breaker, or a power cord failure. First, wait for the power to return. Then, ensure the power cord is properly connected and reset the circuit breaker.
What to do if the Yellow WARNING LED is on and Best Power Patriot Pro II 400 VA has a continuous beep?
This indicates either an output short circuit or a UPS fault. Remove the connected equipment and reset the UPS.
General| Capacity | 400 VA |
|---|---|
| Output Power | 240 Watts |
| Input Voltage | 120 VAC |
| Output Voltage | 120 VAC |
| Output Frequency | 60 Hz |
| Battery Type | Sealed Lead Acid |
| Number of Outlets | 4 |
| Transfer Time | 4-8 ms |
| Waveform Type | Simulated Sine Wave |
| Typical Recharge Time | 8 hours |
| Humidity | 0% to 95% non-condensing |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
Visual identification of front and side views for different Patriot Pro II models.
Explanation of front panel controls, indicators, and their functions.
Details on using RJ-11 or RJ-45 jacks for surge protection.
Table detailing symbols and their corresponding LED meanings for UPS status.
Troubleshooting table correlating problems with possible reasons and solutions.
Detailed explanation of DB-9 connector pin functions for communication.
Explanation of how LEDs indicate selected voltage settings on the UPS.
To Next Page
