Setting up the camera in the field
Once all program settings have been setup properly, the camera is ready for filed use.
Getting Started
Listed below are some helpful pointers on how to use your camera to get the best
results.
Mount the camera about 0.5~2M high with the camera pointed at a slight
downward angle.
Mount the camera facing north or south NOT east or west due to the rising and
setting of the sun could produce false triggers and overexposed images.
If you’re covering a trail, face the camera down or up the trail. Most
commercial cameras take one seconds to sense motion/heat and take a
picture.
Clear all branches and other debris away of the camera’s front side so that you
do not to block the camera lens or PIR sensor. OR This will cause false
pictures caused wind or high temperature days
You can avoid false triggers, you should adjust it, depend on the object or wild
animals’ size, movement speed and distance.
To Next Page
Loading...
Need help?
General