Twill Replace-a-top™ with Tinted Windows – Installation Instructions
Rev. C 0314 79837 pg. 2
Parts List
Fabric Top Qty - 1
Quarter Window, Right Qty - 1
Quarter Window, Left Qty - 1
Rear Window Qty - 1
Elastic Garter Qty - 2
Remove the Quarter Windows and the Rear
Window. Remove the metal Tailgate Bar from the
bottom of the Rear Window and set it aside.
Release the plastic strip sewn to the top above the
doors. Pull down and out to slip the plastic out of the
channel.
Release Plastic Strips
from Retainers
Release the latch that secures the header to the wind-
shield. Pull up on the lever and then down and out to
release the hook from the loop in the windshield frame.
Remove Quarter Windows and
Rear Window
Release Windshield Latches
Release the rear corners of the top. Pull gently
down and then out to release the plastic strip from
the retainer on the vehicle.
Pull down and then out
to release the fabric from
the retainer
Release Rear Corners
Use a phillips screwdriver to remove the four
screws that attach the fl aps in the top to the two
Rear Bows. Set the screws aside to be reused
later. Allow the bows to drop onto the tailgate.
Unscrew the fabric
from the rear bows
Release Rear 2 Bows
View from inside vehicle
Rear Window
Opening
Windshield
Frame
Windshield
Header Latch
Pull lever up
Release hook
from loop
To Next Page
Loading...
